Glass Sculpture Installation at Sprint Center: Day 1

IMG_2070.JPG

This rather boring shot doesn’t indicate much progress for a day’s hard work, but do you see that white ribbon near the top of the column?  Hanging that at the right configuration, and angle, was flat-out tough.  Before doing that we had to get the plywood decking in place, then the lift, then the tools, then bolt up a bunch of steel for all the cables.  After that, we finally were able to begin on the ribbon.

Why are the first sections so critical?  Because if the attitude isn’t right, the whole bloody thing will be off by several feet.  Can’t allow that.

Did we get enough done today?  Hardly; the first day on a big install is often like that.  Expect to make up for it tomorrow though, and start getting some glass in the air.

3 thoughts on “Glass Sculpture Installation at Sprint Center: Day 1

  1. Ich finde Ihre Homepage sehr gut und fundiert. Die Informationen helfen mir bei einer Diplomarbeit für den Bereich der Medizinischen Dokumentation vielen Dank und weiter so.

Leave a Reply